首页

南通行业资讯

当前位置: 首页>>新闻中心>>南通行业资讯

南通流水线装配工艺要求1,:基本要求

南通流水线装配工艺要求1,:基本要求



南通流水线装配基本要求


1,南通流水线装配必须按照设计、工艺要求及本规定和有关标准进行装配。


2,南通流水线装配,装配环境必须清洁。高精度产品的装配环境温度、湿度、防尘量、照明防震等必须符合有关规定。


3,所有零部件(包括外购、外协件)必须具有检验合格证方能进行装配。


4,零件在装配前必须清理和清洗干净, 不得有毛刺、 飞边、 氧化皮、 锈蚀、 切屑、 砂粒、灰尘和油污等,并应符合相应清洁度要求。


5,南通流水线装配过程中零件不得磕碰、划伤和锈蚀。


6,南通自动化装配生产线油漆未干的零件不得进行装配。


7,南通输送流水线 相对运动的零件,装配时接触面间应加润滑油(脂)。


8,各零、部件装配后相对位置应准确。


9,南通流水线装配时原则上不允许踩机操作,特殊部位必须上机操作时应采取特殊措施,应用防护罩盖住被踩部位,操作者须穿平底步鞋以防止破坏漆膜,电瓶及非金属等强度较低部位严禁踩踏。

Assembly line assembly process requirements 1,: basic requirements

Basic requirements for assembly line

1. The assembly line must be assembled in accordance with the design, process requirements, these regulations and related standards.

2. The assembly line must be clean and the assembly environment must be clean. The assembly environment temperature, humidity, dustproof capacity, lighting shockproof, etc. of high-precision products must comply with relevant regulations.

3. All parts (including outsourcing and outsourcing parts) must have inspection certificates before they can be assembled.

4. The parts must be cleaned and cleaned before assembling. There should be no burrs, flashes, oxide scales, rust, chips, sand, dust and oil, etc., and should meet the corresponding cleanliness requirements.

5. Parts must not be bumped, scratched or corroded during assembly line assembly.

6. The wet-painted parts of the automated assembly production line shall not be assembled.

7, Conveying assembly line For relatively moving parts, lubricating oil (grease) should be added between the contact surfaces during assembly.

8. The relative position of the parts and components should be accurate after assembly.

9. In principle, it is not allowed to step on the machine during assembly line assembly. Special measures should be taken when special parts must be operated on the machine. A protective cover should be used to cover the stepped part. The operator must wear flat-bottomed shoes to prevent damage to the paint film, battery and non-standard parts. Stepping on low-strength parts such as metal is strictly prohibited.



服务区域: 安徽 北京 重庆 江苏 山东 上海 天津 浙江 石家庄 廊坊 沈阳 大连 长春 南京 无锡 徐州 常州 苏州 南通 杭州 合肥 芜湖 福州 厦门 济南 青岛 郑州 武汉 长沙 成都 西安