Assembly production line, conveying line: body interior trim plate chain conveying and assembly line: body assembly conveying line adopts plate chain conveyor, tensioning device and driving device are respectively set up on the front and rear ends of the line body, and the length of each station on the wide plate conveyor chain 4.5m, there are 16 parking spaces, and the line is about 75m long.
Assembly line: chain conveyor and assembly line for car body interior trim panels: chain plates are made of high-quality checkered steel plates with a thickness of 6 mm, and all panels are reinforced with ribs.
Assembly line: car body interior trim plate chain conveyor and assembly line: chain plate length is 2m wide and 200mm, chain speed is 0.5m/min-2m/min.
Conveying line: body interior trim plate chain conveying and assembly line: The electrical control system is divided into 1 set of PLC control.
Assembly line: car body interior trim plate chain conveyor and assembly line: the line speed can be set through the equipment management computer system.
In order to improve the reliability of the assembly line: car body interior trim plate chain conveying and assembly line, the unit equipment motor reducer of the conveying system adopts SEW motor.
Assembly line: car body interior trim plate chain conveyor and assembly line, operating speed 0.5m/min-2m/min
Assembly production line: car body interior trim plate chain conveyor and assembly line frequency conversion speed regulation.
Assembly line: The structure of the car body interior trim plate chain conveyor and assembly line chain is detachable, the thickness of the inner and outer plates meets its tensile strength requirements, the thickness of the chain is not less than 8MM, the material is 16Mn, the shaft pin is 40Cr steel and adjusted Quality treatment, the surface hardness of the roller is not less than HRC38, the bearing installed in the chain roller can reduce the running resistance and avoid crawling, and the bearing is lubricated: manufactured by professional manufacturers according to industry standards, quality assurance; pins and rollers are heat treated In the process, the surface of the chain must be shot blasted and treated for rust prevention